Epygi Quadro M26x Guía de instalación descargar pdf (Pagina 23)

QuadroM8L/M26x Manual I: Installation Guide Step 2: Configuring the Quadro

Uplink Configuration

Select the desired WAN Interface Protocol and enter the WAN Interface Bandwidth to as-

sure the quality of IP calls.

Fig. I-21: Uplink Configuration

If the available bandwidth is used to the point where the quality of an additional IP call

would suffer, then new IP calls are rejected.

The bandwidth provided by your ISP must be specified for both Upstream and Down-

stream fields. The default entry in both fields is 100000, the maximum bandwidth of the

100 MB uplink module. For basic DSL and cable modem service in the United States, typi-

cal values are 300 for Upstream and 1500 for Downstream.

The Min Data Rate text field is used to specify the amount of bandwidth reserved for data

applications. The value entered here needs to be smaller that the value specified for Up-

stream Bandwidth.

Specify the WAN Interface Protocol by choosing between available WAN interface proto-

cols: PPPoE (Point to Point over Ethernet), PPTP (Point to Point Tunneling Protocol) and

Ethernet. Use Ethernet for DHCP or static IP.

For Ethernet, clicking Next will display the WAN IP Configuration page. If PPPoE is the

selected WAN Interface Protocol, the next page will be PPP/PPTP Configuration

. For PPTP

WAN Interface Protocol, PPP/PPTP Configuration page will follow the WAN IP Configu-

ration.

QuadroM8L/M26x; (SW Version 5.2.x) 23

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 42 43

Sin comentarios

Epygi Quadro M26x Guía de instalación Pagina 23